How to Install a Brake Light Reversing Camera on an Iveco Daily

Quick Answer

Replace your Iveco Daily's factory high-level brake light housing with a dedicated brake light reversing camera unit for a clean, OEM-fit rear view.

Installation Steps

1. Disconnect Battery and Remove Interior Trim: Disconnect the negative battery terminal. Remove the interior trim panel covering the rear door or tailgate area where the high-level brake light is mounted. Use a trim removal tool to avoid breaking clips. Common mistake: Forgetting to disconnect the battery can cause a short if the reverse light wire is accidentally grounded. Always wait 5 minutes after disconnecting for capacitors to drain.
2. Remove Factory Brake Light Housing: Locate the screws or clips holding the original high-level brake light. Remove them and gently pull the housing away from the body. Unplug the wiring connector from the brake light bulb socket. Checkpoint: If the housing is sealed with adhesive, use a plastic pry tool to break the seal — avoid metal tools that can scratch the paint or crack the lens.
3. Install the Brake Light Camera Unit: Clip or screw the new brake light camera unit into the same mounting points as the original housing. Ensure the rubber gasket sits flush to prevent water ingress. Connect the camera's brake light wiring to the vehicle's brake light plug — typically a two-wire connector for positive and ground. Common mistake: Reversing polarity on the brake light circuit will blow a fuse. Use a multimeter to confirm which wire is 12V+ before connecting.
4. Connect the Video and Reverse Trigger Wires: Run the camera's video cable (RCA) and the red reverse trigger wire to the front of the vehicle. The reverse trigger wire must be connected to the positive wire of one reverse light bulb (use a fuse tap or splice connector). Route the video cable along the roof lining or under the door sill trim, avoiding sharp edges. Checkpoint: The reverse trigger wire is often confused with the brake light wire. Test the reverse light with a multimeter (it only has 12V when the ignition is on and reverse gear is selected).
5. Connect to the Display and Test: Plug the RCA video cable into your aftermarket head unit or monitor's reverse camera input. Turn the ignition on and engage reverse gear. The display should show the camera feed. If not, check all connections and verify the reverse trigger wire is receiving 12V. Common mistake: A black screen usually means the reverse trigger wire is not connected or the head unit's reverse input is not enabled in the settings menu.
6. Secure Wiring and Reassemble Trim: Tuck all excess wiring into the trim cavity and secure with zip ties to prevent rattling. Reattach the interior trim panel and reconnect the battery. Test the camera again, then check that the brake light function still works properly. Checkpoint: After reassembly, test both the brake light and the reverse camera simultaneously — the camera should not interfere with the brake light's brightness or operation.

Product Used in This Guide

• Brake Light Reversing Camera for Iveco Daily Backup Rear Parking Camera: Designed to replace the original high-level brake light housing on Iveco Daily (2014-2022). No drilling or bracket needed — the camera integrates into the factory brake light position for a clean, secure fit.